Filter
Top Products
EliteMail VMS/EliteMail Limited Issue 1
Job Specifications Manual 3 - 43
Message Notification
If you are looking at the Expanded Transfer Options on the subscriber
Personal Directory page, press to close it. The system displays the
Message Notification
part of the screen. This is where you set up
message notification and delivery settings for the subscriber.
Lamp #
Enter the area code and number the voice mail system should dial to
turn a message waiting lamp on or off for the subscriber, and press
. Use
X
for the subscriber extension number.
Activate Lamps?
1. Enter
Y
, and press to indicate if the voice mail system
should activate message waiting lamps.
2. If you select
Y
, also check the Message Lamp On and Off codes
at the top of Switch Setup Screen Page 2 to verify that they are
the correct codes for your telephone system. These codes
were configured automatically when you selected your NEC
telephone system. (Refer to Section 2 Program Worksheet 1:
Site Information on page 3-2.)
3. Enter
N
, and press to indicate if the voice mail system
should not activate message waiting lamps.
Message delivery telephone numbers
Fill in the specifics for each message delivery telephone number on the
last 4 lines of the Message Notification screen. For each telephone
number you want the voice mail system to call to deliver messages, fill in
the following:
For details about the special characters you can use in message delivery
telephone numbers, refer to the EliteMail VMS/EliteMail Limited Technician
Guide. These characters allow you to program pauses and other special
dialing for your NEC telephone system.
#1
Enter the telephone number (or
X
) you want the system to dial, and
press .