Filter
Top Products
Chapter 2 NAS Head 2-109
How do I configure Jumbo Frames support?
Currently this is not supported by the StorEdge software.
Can I set more than one default gateway?
No. The default gateway is the gateway used when a TCP/IP client needs to send
data to a network to which it does not have a specific route. After checking the
destination network against the routing table and finding no match, the data is sent
to the default gateway. There is no provision for TCP/IP to choose between default
gateways.
Some operating systems allow the administrator to configure a second default
gateway to be used in the case of failure of the primary default gateway. StorEdge
does not currently support this feature.
What will happen if I configure multiple network adapters on the
same subnet?
In this case, all outbound traffic will be sent via one network interface. This
unnecessarily limits network bandwidth. The reason that all the network traffic
travels through a single interface is the fact that TCP/IP can only define a single
route to each subnet, and this route can only use one network interface. The solution
is to link the cards at a lower level via port aggregation.
2.26 Quota Configuration
How do I configure user and group quotas? How do I view current
user quotas and disk usage?
Quotas determine how much disk space is available to a user or group, and/or how
many files a user or group can write to a particular volume. The quota allocation is
enumerated according to file ownership. Changing file ownership of files will
change the quota availability.
It is important to note that group quotas apply to an entire group, rather than to
each member. For example, if the users group has a 2GB quota, members will be able
to own a total of 2GB, regardless of how much space is allocated to any particular
user.