Filter
Top Products
Chapter 7 FRU/CRU Replacement Procedures 7-25
8. Disconnect the SFP transceivers and all attached interface cables from the failed
controller. Label all cables such that you can reconnect them correctly to the new
controller.
FIGURE 7-9 Removing an SFP Transceiver and fibre Optic Cable
FIGURE 7-10 Removing and Replacing a Controller
9. Remove the failed controller. Figure 7-10 illustrates the following steps:
a. Push down on the latch.
b. Open the levers.
c. Removed the controller.
10. Does the replacement controller already have a battery installed?