Filter
Top Products
3-20 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
a. To run the Recovery Guru, select the Recovery Guru toolbar button in the Array
Management Window.
b. Complete the recovery procedure.
If the Recovery Guru directs you to replace a failed component, use the individual
lights on the modules to locate the specific failed component. For troubleshooting
procedures, refer to “Troubleshooting and Recovery” on page 3-22.
c. When the procedure is completed, select Recheck in the Recovery Guru to re-
run the Recovery Guru and to ensure that the problem has been corrected.
d. If the problem persists, contact technical support.
11. Replace the cover on the command module, if applicable.
End Of Procedure
3.1.2.6 Responding to the Optional Audible Alarm
The command module may have an optional audible alarm. Modules with the
optional alarm have a Mute button on the front bezel, below the Power and Global
Fault lights. Figure 3-13 on page 3-20 shows the locations of the indicator lights and
the mute button.
FIGURE 3-13 Alarm Mute Button
When one of the following conditions occurs, the alarm sounds and the Global Fault
light illuminates:
■ Hardware malfunction in a command module - Malfunctions include: overheating
conditions, missing fans, or component failures (failed drives, environmental
services monitors [ESMs] or controllers, power supplies, or fans).
■ Transmission failures - Transmission failures include: I/O transmission problems
with the Small Form-factor Pluggable (SFP) transceivers and the interface cables.
The alarm does not affect the operation of the indicator lights or the ability of the
module to report errors to the host.