Filter
Top Products
7-28 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
17. Change the bootstrap protocol (BOOTP) server configuration to the MAC address
you recorded in step 14. For detailed information on the configuration procedure,
refer to your specific operating system administrator's guide.
FIGURE 7-13 Label Locations for the Controller
18. Wait approximately 60 seconds for the storage management software to recognize
the new controller, and then go to step 19.
Caution – Potential data loss. If the battery age is set incorrectly, you may not be
notified to change the battery at the correct time, and data loss could occur. Contact
technical support if the battery age is mistakenly reset.
Note – IMPORTANT During the Recovery Guru procedure, you will be asked to
reset the battery age to zero for the battery and controller that you just installed. If
you used the battery from the failed controller, do not reset the age. If you installed
the new battery, be sure that you reset the age for the battery in the replacement
controller. The software may display a message indicating that the battery in the new
controller has failed or is nearing its expiration date. This message will disappear
after you reset the battery age and the battery is fully charged.
19. Complete any remaining Recovery Guru procedures for battery replacement, if
needed.
20. Based on the status of the Host Link, Drive Link, and Fault lights, choose one of
the following steps. Figure 7-14 shows the locations of these lights.
■ All Link lights are off or the Fault light is illuminated - Verify that the
controller has been installed correctly. Reinstall the controller, and then go to
step 21.
■ All Link lights are on and the Fault light is off - Go to step 22.