Filter
Top Products
7-26 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
■ Yes - Go to step 14.
■ No - If the battery in the failed controller is still viable, you have the option of
using that battery in the replacement controller. Go to step 11.
11. Are you using the battery from the old controller?
■ Yes - Go to step 12.
■ No - Unpack the new battery.
Set the new battery on a dry, level surface. Save all packing materials in case you
need to return the battery, and then go to step 13.
12. Remove the battery from the failed controller.
a. Turn the controller upside down, remove the screws securing the controller
cover, and remove the cover. Figure 7-11 shows the cover and screws.
b. Remove the single screw securing the battery bracket, slide the bracket
sideways to clear the lugs, and lift the bracket up. Figure 7-12 on page 7-27
shows the bracket in relation to the controller.
c. Disconnect the battery harness from its controller board connector.
d. Remove the battery from the controller.
You may need to hold the controller close above a flat surface and let the battery fall
out. Do not let the battery pull on the battery harness.
FIGURE 7-11 Removing the Controller Cover (Upside Down View)
13. Install the replacement battery in the new controller.
a. Connect the battery harness on the replacement battery to the connector on the
controller board in the new controller. Figure 7-12 illustrates this connection.
b. Position the battery inside the new controller.