Filter
Top Products
Chapter 3 Storage Arrays 3-23
■ No - You are finished with this procedure. If you are still experiencing a problem
with this storage array, go to step 10.
7. Remove the cover.
8. If needed, turn off the alarm.
9. Check all of the lights on the front and the back of each module. Figure 3-14 and
Figure 3-15 show the locations of indicator lights. Table 3-2 and Table 3-3 refer you
to the appropriate procedures for various fault indicators. Go to the page
indicated in the tables, and perform the procedure for replacing any failed
component as needed.
10. If you are still experiencing a problem with this storage array, create, save, and
print a storage array profile, and then call technical support for assistance.
The storage array profile may be helpful when troubleshooting.
End of Procedure
FIGURE 3-14 Lights on the Front of a Command Module
TABLE 3-2 Lights on the Front of a Command Module
Location
Component
Light Color Normal Status
Problem
Status Procedure
Drives
1Drive
Active
Green On, not flashing - no
data is being processed
Flashing - data is being
processed
Off “Replacing
a Drive”
on page 7-
36
2Drive FaultAmberOff
Flashing - drive, volume,
or storage array locate
function On, not flashing
On, not
flashing