Filter
Top Products
2-6 Sun StorEdge 5310 NAS Troubleshooting Guide • December 2004
Note – A corded PS/2 keyboard (not a wireless one) must be plugged into the
keyboard/mouse connector at the back of the server. When the front panel is locked,
the lights on the keyboard flash, but the server is still fully functional.
Server Beeps at Power On or When Booting
The server indicates problems with “beep codes” during Power-On Self Test (POST)
in the event there is no displayed video. A complete list of beep codes is given in
“POST Error Beep Codes” on page 2-27.
Note – The RAID card also will beep when a disk drive has failed. Check the system
log to help isolate the problem.
The following beep codes identify system events during POST in case video fails to
display.
TABLE 2-2 Bootup Beep Codes
Beeps Reason
1 One short beep before boot (normal, not an error)
1-2 Search for option ROMs. One long beep and two short beeps on checksum
failure.
1-2-2-3 BIOS ROM checksum
1-3-1-1 Test DRAM refresh
1-3-1-3 Test 8742 keyboard controller
1-3-3-1 Auto size DRAM. System BIOS stops execution here if the BIOS does not
detect any usable memory DIMMs.
1-3-4-1 Base RAM failure. BIOS stops execution here if entire memory is bad.
2-1-2-3 Check ROM copyright notice.
2-2-3-1 Test for unexpected interrupts.
1-5-1-1 FRB failure (processor failure)
1-5-2-2 No processors installed
1-5-2-3 Processor configuration error (for example, mismatched VIDs).
1-5-2-4 Front-side bus select configuration error (for example, mismatched BSELs)