Filter
Top Products
DSL & IAD CLI Reference Guide
117
CHAPTER 19
System Commands
Use these commands to configure system related settings on the ZyXEL Device.
19.1 Command Summary
The following section lists the commands for this feature.
The following table describes input values for some of the sys commands. Other values are
discussed with the corresponding commands.
Table 43 sys Command Input Values
LABEL DESCRIPTION
community The SNMP community (or password).
compare-type Describes the result of a comparison of a packet field with that specified in a rule.
There are four possible values:
0:None -Do not compare the packet field with that specified in the rule.
1:Equal -The packet field value is the same as that specified in the rule.
2:NotEqual -The packet field value is not the same as that specified in the
rule.
3:Less -The packet field value is less than that specified in the rule.
4:Greater -The packet field value is greater than that specified in the rule.
filter-action Sets the action when a filter set is checking a packet. The options are:
forward: This forwards the packet to its destination.
drop: This drops the packet.
checknext: Sets the filter to check the next rule. Use this option if the packet
must be checked against more than one rule.
groupid The number of a tripleplay port-interface group mapping policy.
interface An interface on the ZyXEL Device. These are usually as follows:
enif0: LAN
enif1: WAN
wanif0: PPPoE
If the device supports WLAN then:
enif1: WLAN
enif2: WAN
mail-address An e-mail address
password <32 ASCII characters
ports A list of port numbers.
protocol# 0 = ICMP, 6 = TCP, 17 = UDP