Filter
Top Products
DSL & IAD CLI Reference Guide
95
CHAPTER 15
LAN Interface Commands
Use these commands to configure LAN interfaces on the ZyXEL Device.
15.1 Command Summary
The following section lists the commands for this feature.
Table 35 LAN Command Summary
COMMAND DESCRIPTION
lan active <yes|no> Enables or disables the LAN interface.
lan clear Clears the working buffer for the specified configuration.
Any unsaved changes are lost.
lan dhcp mode <none|server|relay> Sets the DHCP mode.
lan dhcp relay server <ip> Sets the IP address of the DHCP relay server.
lan dhcp server dnsserver <dns-ip1> [<dns-
ip2>]
Sets the IP address of the DNS server assigned to
DHCP clients on this interface.
lan dhcp server gateway <ip> Sets the IP address of the default gateway assigned to
DHCP clients on this interface.
lan dhcp server leasetime <seconds> Specifies how long a device can use the same IP
address before it needs to send a new request for an IP
address.
lan dhcp server netmask <netmask> Specifies the subnet mask assigned to DHCP clients by
the ZyXEL Device.
lan dhcp server pool <startip> <numip> Specifies the range of IP address for DHCP clients.
startip - first IP address in the IP pool.
numip - number of IP addresses in the IP pool.
lan dhcp server rebindtime <seconds> Specifies the time interval from address assignment to
the time the client transitions to rebinding state. A client
in rebinding state broadcasts DHCP request messages.
lan dhcp server renewaltime <seconds> Specifies the time interval from assigning an address
assignment to the time the client transitions to renewing
state. A client in renewing state can try to renew the IP
address lease.
lan display Displays the configuration details for the LAN interface
being configured.
lan filter <incoming|outgoing>
<tcpip|generic> [1] [2] [3] [4]
Applies the specified filter set to this interface. Filter sets
can be configured via the sys filter set command.
1-4: are the index numbers of filters configured via the
sys filter set command.