Filter
Top Products
Chapter 20 VoIP Commands
DSL & IAD CLI Reference Guide
137
• displays the mapping to only phone port 1 for SIP 1 account.
20.4 Analog Phone Commands
Use these commands to configure analog phone features on the ZyXEL Device.
ras> voice config signal index 1
ras> voice config signal phoneselect 1 2 0
ras> voice config signal phoneselect 1 1 1
ras> voice config signal save 1
ras> voice config signal display 1
Mapping phone port: 1
Table 51 Analog Phone Command Summary
COMMAND DESCRIPTION
voice config fxs index <index> Specifies the analog phone port for configuration.
voice config fxs echocancellation <index>
<enable|disable>
Disables or enables echo cancellation.
voice config fxs jittersize <index> <0-90> Sets the jitter buffer size in miliseconds.
voice config fxs vad <index>
<enable|disable>
Disables or enables the VAD (Voice Activity Detection).
voice config fxs dialshortinterval <index>
<interval>
Sets the dialshortinterval value.
This is the time interval (in seconds) that the ZyXEL
Device waits between digits being dialed when making a
call. If time between dialed digits exceeds this value the
ZyXEL Device considers the dialing to be completed and
calls the number entered.
Enter a value between 0-256.
voice config fxs diallonginterval <index>
<interval>
Sets the diallonginterval value.
This is the time interval (in seconds) that the ZyXEL
Device waits until the first digit is dialed when making a
call. If no digit is dialed in this time period the ZyXEL
Device sends a busy signal.
Enter a value between 0-256.
voice config fxs flashmaxinterval <index>
<interval>
Sets the flash key maximum interval (in miliseconds).
If the flash key is pressed for a longer period, then it will
be ignored. Users must press the flash key for a period of
time smaller than the flash key maximum interval but
greater than the flash key minimum interval for it to be
recognized by the system.
Enter a value between 0~65535.
voice config fxs flashmininterval <index>
<interval>
Setup flash key minimum interval.
If the flash key is pressed for a shorter period, then it will
be ignored. Enter a value between 0~65535.
voice config fxs inputvolume <index>
<volume>
Sets the input volume level.
The level can be in the range -14 to 14.
voice config fxs outputvolume <index>
<volume>
Sets the output volume level.
The level can be in the range -14 to 14.
voice config fxs sipselect <index> <phone-
port|0:All> <0:no|1:yes>
Configures an analog phone to SIP account mapping
and enables the specified SIP account.