Filter
Top Products
Chapter 20 VoIP Commands
DSL & IAD CLI Reference Guide
135
voice config signal phoneselect <index>
<phone-port|0:All> <0:No|1:Yes>
Sets the physical FXS port mapping to this SIP account
for incoming calls. In other words, specifies which analog
phone rings when a call is received for this SIP account.
phone-port: this is an FXS port on the ZyXEL Device.
Enter 0 to select all FXS ports.
voice config signal vlantag <index>
<disable|enable>
Enables or disables VLAN tags in VoIP packets.
voice config signal tpid_vlantag <index>
<tpid>
Sets the value of the TPID (Tag Protocol Identifier) in the
VLAN tag header of VoIP packets.
voice config signal vid_vlantag <index>
<vlan-id>
Sets the VLAN ID of VoIP packets sent via this SIP
account.
voice config signal priority_vlantag
<index> <priority:0-7>
Sets the VLAN priority value of outgoing VoIP packets.
voice config signal diffservrtp <index>
<0-255>
Sets the DiffServ value in the IP header of outgoing RTP
packets for this SIP account.
voice config signal diffservsip <index>
<0-255>
Sets the DiffServ value in the IP header of outgoing SIP
packets for this SIP account.
voice config signal mwiactive <index>
<0:off|1:on>
Enables or disables the message waiting indication.
voice config signal mwitimeout <index>
<minutes>
Sets the MWI time out value.
voice config signal rfc3325 <index><1:
privacy call using RFC3325, 0: privacy
call using draft-01>
Enables or disables the sending of identity information
between SIP devices as described in RFC 3325.
voice config signal prack <index>
<0:off|1:on>
Enables or disables sending of PRACK messages as
described in RFC 3262 for this SIP account.
voice config signal fakesipactive <index>
<0:off|1:on>
Enables a fake SIP service for this SIP account.
This feature is used by ZyXEL Devices which are behind
a NAT router that does not support SIP ALG.
If a ZyXEL Device has a private IP address on its WAN
interface, then it may have to provide a public IP address
along with a listening port of the Internet gateway (for
example a DSL modem) to which it is connected. This
fake IP address and port number ensure that SIP
packets are successfully routed back to the ZyXEL
Device from the Internet.
voice config signal fakesipservaddr
<index> <ip>
Sets a fake SIP server address for this SIP account.
voice config signal fakesipservport
<index> <port>
Sets a fake SIP server port for this SIP account.
voice config signal outboundactive <index>
<0:off|1:on>
Enables or disables a SIP outbound proxy configuration
for this SIP account.
voice config signal outboundaddr <index>
<ip>
Sets the address of the SIP outbound proxy server.
voice config signal outboundport <index>
<port>
Sets the port number of the SIP outbound proxy server.
voice config signal outboundkaactive
<index> <0:off|1:on>
Enables or disables NAT keep alive service.
Table 50 SIP Account Command Summary
COMMAND DESCRIPTION