Filter
Top Products
Chapter 19 System Commands
DSL & IAD CLI Reference Guide
121
sys filter set protocol
[protocol#]
Sets the rule to match a specified protocol. 0 sets the rule to match
any protocol.
TCP/IP rules only.
sys filter set save Saves the set’s configuration.
sys filter set sourceroute
[yes|no]
Enables or disables the filtering of packets based on whether their
sourceroute option is enabled or not.
TCP/IP rules only.
sys filter set srcip [source-
ip][mask]
Sets the source IP address and subnet mask of the set.
TCP/IP rules only.
sys filter set srcport [source-
port][compare-type]
Sets the source port and compare type.
TCP/IP rules only.
sys filter set tcpestab [yes|no] yes sets the rule to match packets that request a TCP/IP connection.
no sets the rule to ignore this behavior.
TCP/IP rules only.
sys filter set type
[tcpip|generic]
Sets the type of filter rule.
tcpip: Choose TCP/IP filtering to filter packets based on source and
destination IP address, destination port and protocol.
generic: Choose generic filtering to filter packets based on bit
pattern matching.
sys filter set value [value] Sets the value of the data to be compared with the packet data
delimited by the offset and length values.
value: Enter this three byte value in hexadecimal notation, e.g.,
F:F:F.
Generic rules only.
sys filter sw Turns on or off the filtering counter switch.
sys firewall See Chapter 12 on page 67 for details on the these commands.
sys general bridge <on|off> Enables or disables system bridging.
sys general contactname
[contact-name]
Sets the contact person’s name.
sys general display Displays general system configuration information, including
hostname. domain name. location, contact details and system mode.
sys general domainname [domain-
name]
Sets the domain name.
sys general hostname [host-name] Sets the system name.
sys general load Loads general system information into the buffer.
sys general location [location] Sets the geographical location of your device.
sys general routip <on|off> Enables or disables system routing.
sys general save Saves general information to non-volatile memory.
sys hostname [hostname] Sets or displays the system hostname.
sys logs category 8021.x
[0:none|1:log]
Activates or deactivate logging for IEEE 802.1X authentication
requests.
sys logs category access
[0:none|1:log|2:alert|3:both]
Sets whether a log and/or an alert is made for requests for access.
sys logs category anyip
[0:none|1:log]
Enables or disables recording of AnyIP logs and/or sending an alert.
Table 44 sys Commands (continued)
COMMAND DESCRIPTION