Filter
Top Products
DSL & IAD CLI Reference Guide
37
CHAPTER 5
Dial Backup Commands
Use these commands to configure dial backup port settings on the ZyXEL Device.
" At the time of writing, only P-662 series has the commands described in this
chapter.
5.1 Command Summary
The following table describes the values required for many dial backup commands. Other
values are discussed with the corresponding commands.
The following section lists the aux commands.
Table 9 AUX Command Input Values
LABEL DESCRIPTION
aux-port This identifies the channel for dial backup.
aux0: This is the dial backup port.
Table 10 AUX Commands
COMMAND DESCRIPTION
aux atring <aux-port> Shows the AT command binary strings that the ZyXEL Device
sent to the connected modem and the responses.
aux clearstat <aux-port> Resets channel statistics.
aux cnt disp <aux-port> Displays the auxiliary port’s counter information.
aux cnt clear <aux-port> Clears the auxiliary port’s counter information.
aux drop <aux-port> Disconnects the auxiliary port’s connection.
aux init <aux-port> Initializes the the auxiliary port’s connection.
aux mstatus <aux-port> Displays the status of the modem’s last call.
aux mtype <aux-port> Displays the type of modem connected to the auxiliary port.
aux netstat <aux-port> Displays upper layer packet information and the
corresponding transmit and receive counts.
aux rate <aux-port> Displays the transmit and receive rates.
aux signal <aux-port> Displays the auxiliary port’s signal.