Filter
Top Products
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
165
wan node display Displays configuration details of the previously-
specified WAN node currently in the working buffer.
wan node enable Activates the previously-specified WAN node
profile.
wan node encap
<1483|pppoa|pppoe|enet>
Sets the encapsulation method used by the
previously-specified WAN node profile.
<1483>: RFC1483
<pppoa>: Point-to-Point Protocol over ATM
<pppoe>: Point-to-Point Protocol over Ethernet
<enet>: Ethernet encapsulation.
wan node filter
<incoming|outgoing|call>
<tcpip|generic> <profile>
Specifies the filter action, type and profile to be used
for traffic to or from the previously-specified WAN
node profile.
incoming: the filter applies to traffic coming from
the WAN to the LAN.
outgoing: the filter applies to traffic coming from
the LAN to the WAN.
call: determines whether a packet should be
allowed to trigger a call.
tcpip: filters IP packets only.
generic: filters based on a packet’s MAC address.
profile: profile number 1 ~ 4. Use the sys
filter set commands to configure filter profiles.
wan node freememory Clears the WAN node information in the working
buffer.
Note: Use this command before working
on another WAN node profile.
wan node index <node#> Sets the node pointer to the specified WAN node
profile.
• 1 is the ISP node profile.
• 9 is the backup node profile.
Note: Use this command to specify the
node profile before using other wan
node commands.
wan node ippolicy <profile#> Sets the IP policy profile to be used by the
previously-specified WAN node profile.
profile#: profile number 0 ~ 12.
wan node ispname <name> Sets the ISP name for the node you previously
specified with the wan node index <node#>
command.
wan node mbs <mbs> Sets the Maximum Burst Size (MBS) of the
previously-specified WAN node profile.
wan node metric <metric> Sets the metric value (number of transmission hops)
of the previously-specified WAN node profile.
wan node mtu <512~1500> Sets the Maximum Transmission Unit (MTU) to
define the size of the largest packet allowed on the
specified WAN node.
Table 66 wan node Commands (continued)
COMMAND DESCRIPTION