Filter
Top Products
DSL & IAD CLI Reference Guide
61
CHAPTER 10
VoIP DECT Commands
Use these commands to configure DECT (Digitally Enhanced Cordless Telecommunications)
settings on the ZyXEL Device.
These commands are only available on ZyXEL Devices which have a DECT cordless phone
base station.
10.1 Command Summary
The following section lists the commands for this feature.
Table 23 dect Command Summary
COMMAND DESCRIPTION
voice config dect index <index> Loads the DECT settings for configuration.
voice config dect bspassword
<index> <base-station-password>
Sets the base station password. This is the password that DECT
phones must enter when registering with the base station.
base-station-password: 4 digit number, for example “0987”.
voice config dect save <index> Saves the DECT configuration on the ZyXEL Device.
voice config dect display <index> Shows the base station password.
index: 1
voice dect page Pages all handset registered with the base station on the ZyXEL
Device.
voice dect reset Resets the base station and initiates it.
voice dect handsetlist Displays the list of registered handsets.
voice dect version Displays the base station firmware version.
voice dect upgradefw Upgrades the base station firmware via a console. The DECT
upgrade should only be performed by a service technician.
voice dect subscript Enables DECT subscription to allow DECT phones to register with
the base station.
voice dect restoredectrom Resets the DECT module to the factory defaults.
voice dect fwupgrade Upgrades the base station firmware via a console. The DECT
upgrade should only be performed by a service technician.
voice dect clearhandset Removes the list of registered handsets.
voice dect fwversion Displays the base station firmware version.