Chapter 13 IP Commands
DSL & IAD CLI Reference Guide
75
ip policyrouting set criteria
destport <start-port> <end-
port>
Sets the IP policy route destination ports.
ip policyrouting set action
actmatch
Sets the criteria if a packet does not match the IP policy
route rule for further action.
ip policyrouting set action
actnomatch
Sets the criteria if a packet matches the IP policy route rule
for further action.
ip policyrouting set action
gatewaytype <1:WAN-remote-node
|0:gateway-address>
Sets IP policy route gateway type.
ip policyrouting set action
gatewayaddr <ip-address>
Sets the action the ZyXEL Device forwards the packet by
the specified IP address.
ip policyrouting set action
gatewaynode <1-8>
Sets the action the ZyXEL Device forwards the packet by
the specified ZyXEL Device's WAN remote node.
ip policyrouting set action
servicetype <0:don’t care|1:
normal|2:min delay|3: max
thruput|4:max reliable|5:min
cost>
Sets the action to change the service type or not.
ip policyrouting set action
precedence <0~7|8:no change>
Sets the action to change the precedence or not.
ip policyrouting set action
log <yes|no>
Sets the action to enable logging or not.
ip policyrouting set display
<set-number> <rule-number>
Displays the specified IP routing policy rule setting.
ip policyrouting set save Saves the IP policy route rule setting from working buffer to
non-volatine memory.
ip policyrouting set
freememory
Clears the IP policy route settings in the working buffer.
ip policyrouting set clear
<set-number> [rule-number]
Deletes a IP policy route set or rule settings in the non-
volatile memory.
ip policyrouting clear Clears the IP policy route count.
ip policyrouting disp Displays the IP policy route count.
ip policyrouting switch
[on|off]
Switchs on or off the IP policy route count.
ip rip accept <gateway> Drops an entry from the RIP (Routing Information Protocol)
refusing list.
ip rip activate Enables RIP.
ip rip merge [on|off] Sets RIP merge flag.
ip rip refuse <gateway> Adds an entry to the RIP refuse list.
ip rip request <address>
[port]
Sends RIP request to some address and port.
ip rip reverse [on|off] RIP Poisoned Reverse.
ip rip status Displays RIP statistic counters.
ip rip trace [number] Enables the RIP trace flag for debugging.
Table 30 IP Commands (continued)
COMMAND DESCRIPTION