Filter
Top Products
Chapter 20 VoIP Commands
DSL & IAD CLI Reference Guide
134
voice config signal minse <index> <20-
1800>
Sets the minimum number of seconds the ZyXEL Device
accepts for a session expiration time when it receives a
request to start a SIP session.
voice config signal serveraddress <index>
<ip>
Sets the SIP server address for this SIP account.
voice config signal serverport <index>
<1024-65535>
Sets the SIP server’s listening port for this SIP account.
voice config signal registeraddress
<index> <ip>
Sets the SIP register server address for this SIP account.
voice config signal registerport <index>
<1024-65535>
Sets the SIP register server’s listening port for this SIP
account.
voice config signal userid <index>
<username>
Sets the SIP username for this SIP account.
voice config signal password <index>
<password>
Sets the SIP password for this SIP account.
voice config signal urltype <index>
<sip|tel>
Sets the SIP URL type for this SIP account.
sip: SIP messages are sent to domain name or IP
address.
tel: SIP messages are sent to addresses represented
as telephone numbers.
voice config signal port <index> <1024-
65535>
Sets the ZyXEL Device’s SIP listening port for this SIP
account.
voice config signal phonenumber <index>
<0-32>
Sets the SIP number for this SIP account.
voice config signal domain <index>
<domain>
Sets the SIP service domain name.
domain: 1-128 alphanumeric characters.
voice config signal dtmf <index>
<rfc2833|pcm|sipinfo|rfc2833like>
Sets the method for sending the tones created by
pressing buttons on your phones keypad.
rfc2833: sends DTMF tones in RTP packets.
pcm: sends DTMF tones in voice data stream.
sipinfo: sends DTMF tones in SIP messages.
rfc2833like: Sends the information in SIP messages
with an RTP payload.
voice config signal pri_compression
<index> <0:G711mu|8:G711A|18:G729>
Sets the primary compression (voice codec) type for this
SIP account.
voice config signal sec_compression
<index> <0:G711mu|8:G711A|18:G729>
Sets the secondary compression (voice codec) type for
this SIP account.
voice config signal portrange <index>
<start-port> <end-port> (40000~65535)
Sets the port range for RTP/RTCP communication.
voice config signal transport <index>
<udp|tcp>
Sets the protocol for sending SIP messages.
voice config signal callerid <index>
<disable|enable>
Enables or disables the caller ID feature for this SIP
account.
voice config signal autoredialpstn <index>
<disable|enable>
Enables or disables the auto-redial feature for this SIP
account.
Table 50 SIP Account Command Summary
COMMAND DESCRIPTION