Filter
Top Products
Chapter 11 Ethernet Commands
DSL & IAD CLI Reference Guide
64
11.2 Command Examples
This example changes the LAN speed of a ZyXEL Device with one Ethernet LAN port to 10
Mbps and full duplex.
This example set the speed of LAN port 3 in the ZyXEL Device with a four-port switch to 10
Mbps and full duplex. This also displays the link status, speed and duplex mode of each
Ethernet port.
ether edit mtu <value> Sets the Ethernet Maximum Transmission Unit (MTU)
size for the specified interface.
ether edit accessblock
<0:disable|1:enable>
Allows or disallows packets through the specified
interface.
ether edit save Saves the Ethernet configuration.
ether portStatus Displays whether the port is connected and the speed of
the connection.
ether switch cnt
<all|clear|0|1|2|3|4|5>
Displays or removes the Ethernet port’s packet statistics.
ether switch igmpsnp disable Deactivates IGMP snooping on the ZyXEL Device.
ether switch igmpsnp enable Activates IGMP snooping on the ZyXEL Device.
ether switch igmpsnp status Displays whether or not IGMP snooping is enabled on
the ZyXEL Device.
ether switch speedDuplex <port-
id> [a|m =auto|manual] [10|100]
[h|f =half|full-duplex]
Sets an Ethernet port’s connection speed and duplex
mode. This command is for a ZyXEL Device with a four-
port switch only.
port-id: all|1|2|3|4
ether switch status Displays the link status, speed and duplex mode of each
Ethernet port.
ether version Displays the Ethernet driver version.
Table 25 Ethernet Commands (continued)
COMMAND DESCRIPTION
ras> ether driver config 1 0 1 enet0
ras> ether switch speedDuplex 3 m 10 f
Done
ras> ether switch status
Port# Link Speed Duplex
1 - - -
2 - - -
3 Y 10 Full
4 Y 100 Full
ras>