Filter
Top Products
Chapter 14 IPSec Commands
DSL & IAD CLI Reference Guide
90
ipsec dial <rule-number> Dials the specified IPSec policy manually.
ipsec display <rule-number> Displays the specified IPSec rule. Use ipsec load to
load an IPSec rule before using this command.
ipsec load <rule-number> Loads the specified IPSec rule for editing.
ipsec save Saves the IPSec rule settings.
ipsec config netbios active <on|off> Sets whether or not NetBIOS packets are allowed to pass
through VPN tunnels.
ipsec config name <name> Sets the rule’s name (up to 32 characters).
ipsec config active <Yes|No> Turns the rule on or off.
ipsec config natTraversal <Yes|No> Turns NAT traversal on or off.
ipsec config keepAlive <Yes|No> Turns keep alive on or off.
ipsec config lcIdType <0:IP|1:DNS |
2:Email>
Sets the local ID type.
ipsec config lcIdContent <content> Sets the local ID content with the specified IP address,
domain name, or e-mail address. Use up to 31 characters.
ipsec config myIpAddr <ip-address> Sets the local VPN gateway with the specified IP address.
ipsec config peerIdType
<0:IP|1:DNS|2:Email>
Sets the peer ID type.
ipsec config peerIdContent <content> Sets the peer ID content with the specified IP address,
domain name, or e-mail address. Use up to 31 characters.
ipsec config secureGwAddr <ip-
address|domain-name>
Sets the remote gateway address with the specified IP
address or domain name.
ipsec config protocol <1:ICMP
|6:TCP|17:UDP>
Sets the traffic protocol that can trigger the VPN tunnel
and be forwarded through it.
ipsec config lcAddrType
<0:single|1:range|2:subnet>
Sets the address type for the local network.
ipsec config lcAddrStart <ip-address> Sets the local network starting IP address.
ipsec config lcAddrEndMask <ip-address> Sets the local network ending IP address for a range or
the subnet mask for a subnet.
ipsec config lcPortStart <port> Sets the starting port for local network traffic. Only traffic
using the specified ports can go through the VPN tunnel.
ipsec config lcPortEnd <port> Sets the ending port for local network traffic.
ipsec config dynamicLocal <On|Off> Sets the local network IP address range to be dynamic
(any).
ipsec config rmAddrType
<0:single|1:range|2:subnet>
Sets the address type for the remote network.
ipsec config rmAddrStart <ip-address> Sets the remote network starting IP address.
ipsec config rmAddrEndMask <ip-address> Sets the remote network ending IP address for a range or
the subnet mask for a subnet.
ipsec config rmPortStart <port> Sets the starting port for remote network traffic. Only traffic
using the specified ports can go through the VPN tunnel.
ipsec config rmPortEnd <port> Sets the ending port for remote network traffic.
ipsec config dynamicRemote <On|Off> Sets the remote network IP address range to be dynamic
(any).
Table 34 IPSec Commands (continued)
COMMAND DESCRIPTION