Filter
Top Products
Chapter 22 Wireless LAN Commands
DSL & IAD CLI Reference Guide
188
22.2 Command Examples
This section shows how to use the wireless LAN commands in some example scenarios.
22.2.1 WLAN Setup Example
The example varies depending on the commands you can use on your ZyXEL Device.
The following example:
• Activates the WLAN.
• Sets the wireless channel to 6.
• Sets the SSID to “ZyWiFi”.
• Sets the MAC address filter to deny association to devices on its list.
• Adds the MAC address “fa:fa:fa:fa:fa:fa” to the MAC address filter list slot 1.
• Activates the MAC filter.
• Sets the WEP type to 128-bit.
• Configures the WEP key 1 to be “1234567890123”.
• Sets the ZyXEL Device to use WEP key 1.
• Turns on QoS.
• Sets the QoS to AP mode.
• Configures the Voice QoS settings with an aifs of 9µs, a cwmin of 7 and a cwmax of
15, a txop-b of 250 and a txop-g of 250.
• Saves the configuration.
• Displays the configuration.
wlan wps release <Yes:1|No:0> Enables or disables removing of all configured
wireless and wireless security settings for WPS
connections.
wlan wmm active <Yes:1|No:0> Enables or disables the WMM feature on the ZyXEL
Device.
Table 69 General Wireless Commands (continued)
COMMAND DESCRIPTION