ZyXEL Communications n/a Modem User Manual


 
Chapter 19 System Commands
DSL & IAD CLI Reference Guide
119
sys ddns config emailaddress
<mail-address>
Sets your email address. First allocate memory by using sys ddns
config load.
sys ddns config hostname
<domain-name>
Sets the domain name provided by your ISP. First allocate memory by
using sys ddns config load.
sys ddns config load Loads dynamic DNS to the working buffer for configuration and use.
sys ddns config password
<password>
Sets the password. (This command may not be supported in your
ZyXEL Device.)
First allocate memory by using sys ddns config load.
sys ddns config save Saves the dynamic DNS settings to non-volatile memory.
sys ddns config username
<username>
Sets the DDNS user name (<32 ASCII characters).
This command may not be supported in your ZyXEL Device.
sys ddns debug <level> Enables or disables DDNS debug mode.
sys ddns display <interface> Displays DDNS information for the specified interface, including
DDNS status and connection details.
sys ddns logout <interface> This logs out DDNS on the specified interface. This should be a WAN
interface.
sys ddns restart <interface> Restarts DDNS on the specified interface. This should be a WAN
interface.
sys default Resets the device to its default values, except for LAN settings which
are reserved. If default LAN settings are also required, use sys
romreset.
sys diag Displays the system version, CPU usage, and mbuf status. mbuf is
the memory buffer used to store network packets.
sys display Displays system information on the hostname, location and system
modes.
sys domainname [domain-name] Sets or displays the domain name.
sys edit <file-name> Edits the system preset text files such as autoexec.net.
sys feature Displays information on available features.
sys filter clear Remove the filter statistics.
sys filter disp Shows the filter statistics.
sys filter netbios config
<0|1|2|3|4><on|off>
Turns the netbios filter on or off for the specified traffic.
0:Between LAN and WAN
1:Between LAN and DMZ
2:Between WAN and DMZ
3:IPSec passthrough
4:Trigger Dial
For options 1-3, on = block, off = forward.
For option 4, on = enable, off = disable.
If your device does not support DMZ then options 1 and 2 will not be
available.
sys filter netbios display Displays the netbios filter status.
sys filter set actmatch [filter-
action]
Sets the action to be performed when a packet matches the set
description.
sys filter set actnomatch
[filter-action]
Sets the action to be performed when a packet does not match the
set description.
Table 44 sys Commands (continued)
COMMAND DESCRIPTION