Filter
Top Products
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
163
21.6 wan node Commands
Use these commands to configure the WAN ISP and backup nodes.
Table 66 wan node Commands
COMMAND DESCRIPTION
wan node backup <enable|disable> Activates or deactivates the backup WAN node.
Note: Use the wan node index 9
command to specify the backup
WAN node.
wan node backup filter
<incoming|outgoing> <profile>
Sets the filter action and profile to be used by the
previously-specified WAN backup node.
incoming: the filter applies to traffic coming from
the WAN to the LAN.
outgoing: the filter applies to traffic coming from
the LAN to the WAN.
profile: profile number 1 ~ 4. Use the sys
filter set commands to configure filter profiles.
wan node backup idletimeout
<seconds>
Sets the idle timeout for the previously-specified
WAN backup node.
wan node backup ispname <name> Sets the ISP name for the previously-specified WAN
backup node.
wan node backup metric <metric> Sets the metric value (number of transmission hops)
for the previously-specified WAN backup node.
wan node backup multicast
<none|igmpv1|igmpv2>
Sets the multicast mode of the previously-specified
WAN backup node.
wan node backup nailedup <on|off> Activate or deactivate a nailed-up (always on)
connection for the previously-specified WAN backup
node.
wan node backup nat <off|sua|full
<address mapping rule #>>
Sets the Network Address Translation (NAT) mode
of the previously-specified WAN backup node.
<off>: NAT is not active
<sua>: Use Single User Account only (if you have
just one public WAN IP address for your ZyXEL
Device).
<full> : Use full-feature NAT (if you have multiple
public WAN IP addresses for your ZyXEL Device).
<address mapping rule #> : When you choose
full-feature NAT, specify the address mapping rule
to apply. Use the ip nat addrmap rule
command to configure address mapping rules.
wan node backup ppp authen
<chap|pap|both>
Sets the authentication method for the backup WAN
node (use the wan node index 9 command to
specify the backup WAN node).
wan node backup ppp idletime
<seconds>
Sets the PPP idle timeout for the previously-
specified backup WAN node.
wan node backup ppp password
<password>
Sets the password for the previously-specified
backup WAN node.
wan node backup ppp username <name> Sets the username for the backup WAN node (use
the wan node index 9 command to specify the
backup WAN node).