ZyXEL Communications n/a Modem User Manual


 
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
169
21.7 wan tr069 Commands
Use these commands to configure the ZyXEL Device’s TR-069 auto-configuration settings.
Table 67 wan tr069 Commands
COMMAND DESCRIPTION
wan tr069 acsUrl <url> Specifies the URL of the TR-069 auto-configuration
server.
wan tr069 active <0:no|1:yes> Activates or deactivates remote management via
TR-069 on the WAN.
wan tr069 debug <on|off> Activates or deactivates TR-069 debugging.
wan tr069 display Shows the current TR-069 configuration.
wan tr069 dump dbglog Displays TR-069 logs.
wan tr069 dump notification Shows the TR-069 notification parameter table.
wan tr069 dump parameters [name]
[NextLevel] [flag]
Shows a list of TR-069 notification parameters.
wan tr069 gateway active
<0:no|1:yes>
Enables or disables remote management through a
NAT router.
wan tr069 gateway display Shows the current TR-069 gateway status.
wan tr069 gateway notifylimit
<seconds>
Sets the time interval at which the gateway notifies
the ACS when a Device entry is added to or
removed from the ManageableDevice table.
The gateway is a NAT router between the ZyXEL
Device and the ACS.
wan tr069 informInterval <seconds> Sets the frequency with which the ZyXEL Device
sends information to the auto-configuration server.
wan tr069 informTime <yyyy>-<mm>-
<dd>T<hh>:<mm>:<ss>
Sets the date and time at which the ZyXEL Device
sends information to the auto-configuration server.
wan tr069 load Loads the TR-069 configuration.
wan tr069 password <password> Sets the TR-069 password for authentication with
the auto-configuration server.
wan tr069 periodicEnable
<0:disable|1:enable>
Enables or disables the periodic sending of
information to the auto-configuration server.
wan tr069 reqpassword <password> Sets the TR-069 connection request password.
When the auto-configuration server makes a
connection request to the ZyXEL Device, this
password is used to authenticate the auto-
configuration server.
wan tr069 reqport <1001 ~ 65535> Sets the port number of the TR-069 connection
request.
wan tr069 requsername <username> Sets the TR-069 connection request user name.
When the auto-configuration server makes a
connection request to the ZyXEL Device, this user
name is used to authenticate the auto-configuration
server.
wan tr069 reset Resets the TR-069 configuration to its factory
defaults.
wan tr069 routeRN <0 ~ 7> Sets the remote node through which the ZyXEL
Device routes the TR-069 connection requests.