Filter
Top Products
Chapter 20 VoIP Commands
DSL & IAD CLI Reference Guide
144
20.7.1 VoIP Auto-Provisioning Command Examples
This example enables auto-provisioning on the ZyXEL Device. Specifies the IP address of the
auto-provisioning server (172.16.1.201). Sets auto-provisioning to use HTTPS to transmit data
and specifies which auto-provisioning file to receive by providing the phone number
associated with the configuration file.
20.8 VoIP PSTN Line Commands
Use these commands to configure the PSTN line on the ZyXEL Device.
voice config autopro save <index> Saves the speed dial entry in the working buffer to non-
volatile memory.
The working buffer is a volatile memory space. The
settings in the working buffer are not applied to the
ZyXEL Device until you execute this command.
voice config autopro display <index> Displays the saved values for the speed dial entry.
voice config autopro dumpCfg <index> Displays the configured values in the working buffer for
the specified configuration.
Table 54 Auto-Provisioning Command Summary
COMMAND DESCRIPTION
ras> voice config autopro index 1
ras> voice config autopro active 1 1
ras> voice config autopro servaddr 1 172.16.1.210
ras> voice config autopro protocol 1 2
ras> voice config autopro phonenumber 1 5555555
ras> voice config autopro save 1
Table 55 PSTN Line Command Summary
COMMAND DESCRIPTION
voice config fxo index <index> Selects a PSTN line index for configuration.
voice config fxo fxolongdial <index>
<long-dial-interval>
Sets the diallonginterval value.
This is the time interval (in seconds) that the ZyXEL
Device waits until the first digit is dialed when making a
call. If no digit is dialed in this time period the ZyXEL
Device sends a busy signal.
Enter a value between 0-256.
voice config fxo dtmfpausedur <index>
<short-dial-interval>
Sets the dialshortinterval value.
This is the time interval (in seconds) that the ZyXEL
Device waits between digits being dialed when making a
call. If time between dialed digits exceeds this value the
ZyXEL Device considers the dialing to be completed and
calls the number entered.
Enter a value between 0-256.
voice config fxo dtmfdigitdur <index>
<dtmf-duration>
Sets the duration of time that the ZyXEL Device sends
DTMF signals through the FXO interface.
If this setting
is set to 0, then the duration becomes 500 ms.