Filter
Top Products
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
158
21.3.1 wan backup Examples
The following example:
• Loads the WAN backup configuration information.
• Specifies the following IP addresses to check: 192.168.1.100, 192.168.1.150,
192.168.1.175
• Sets the ZyXEL Device to periodically ping the IP addresses.
• Sets the timeout in seconds for an ICMP ping to 5.
• Sets the tolerance to 5.
• Sets the recovery interval to 60.
• Activates dial backup.
• Sets the AT command used to answer a call to "A0".
• Sets the number of seconds the ZyXEL Device tries to make a call before timing out to 20.
• Sets the number of times the ZyXEL Device tries a busy or no-answer phone number
before blacklisting it to 10.
• Sets the dial backup port speed to 9600.
• Saves the current setting in the WAN backup working buffer to the permanent memory.
wan backup tolerance <0~9> Sets the number of failed responses the ZyXEL
Device may receive when pinging the checkip IP
addresses before switching to a WAN backup
connection.
wan backup trafficredirect active
<0:no|1:yes>
Activates or deactivates traffic redirection to a
backup gateway.
wan backup trafficredirect backIp
<address>
Sets the backup gateway’s IP address for traffic
redirection.
wan backup trafficredirect metric
<number>
Specifies the metric value for traffic redirection.
Table 63 wan backup Commands (continued)
COMMAND DESCRIPTION