Filter
Top Products
DSL & IAD CLI Reference Guide
33
CHAPTER 3
IEEE 802.1Q/1P Commands
Use these commands to configure IEEE 802.1Q VLAN groups and IEEE 802.1P priority
levels for the ports on the ZyXEL Device.
3.1 Command Summary
The following section lists the commands for this feature.
Table 7 8021Q Command Summary
COMMAND DESCRIPTION
802.1Q load Loads the IEEE 802.1Q settings for configuration.
802.1Q disp Shows the current IEEE 802.1Q settings.
802.1Q clear Resets the IEEE 802.1Q settings to the factory defaults.
802.1Q active <1:active|0:inactive> Enables or disables the IEEE 802.1Q feature on the
ZyXEL Device.
802.1Q mgtvid <1~4094> Sets the ID number of the management VLAN group.
802.1Q setpvid <LAN|PVC|WLAN> <index>
<1~4094>
Sets the port VLAN ID of the specified interface on the
ZyXEL Device.
802.1Q set1p <LAN|PVC|WLAN> <index> <0~7> Sets the IEEE 802.1P priority level of the specified
interface on the ZyXEL Device.
802.1Q groupset <groupid> <vid> <LAN
<index>|<PVC|WLAN> <index>> <u|t>
Sets a VLAN group.
u|t: Sets the interface to tag or untag all outgoing traffic
transmitted through this VLAN.
802.1Q setlanAttri LAN <index> <t|u> Sets an Ethernet port to tag or untag all outgoing traffic
transmitted.
802.1Q igmpsnp enable Enables IGMP snooping.
802.1Q igmpsnp disable Disables IGMP snooping.
802.1Q igmpsnp maxresptime <0~255> Sets the maximum response time that can elapse before
the ZyXEL Device removes an IGMP group membership
entry.
802.1Q igmpsnp queryinterval <0~255> Sets the IGMP snooping query interval (in seconds) at
which the ZyXEL Device sends host-query messages.
802.1Q igmpsnp robust <0~255> Sets the IGMP robust value.
802.1Q igmpsnp disp Displays the IGMP table on the ZyXEL Device.
802.1Q save Saves the IEEE 802.1Q settings.