ZyXEL Communications n/a Modem User Manual


 
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
167
21.6.1 wan node Examples
The following example:
Sets the active node profile to node 1 (the ISP node profile).
Sets the profile name to "ISP1".
Sets the multicast mode to IGMP version 2.
Sets the NAT mode to SUA only.
Sets the PPP authentication method to CHAP.
Sets the PPP username to "User1".
Sets the PPP password to "Pass1".
Sets the PPP idle timeout to 240 seconds.
Sets the remote gateway IP address to 192.168.1.254, with a subnet mask of
255.255.255.0.
Activates IP routing.
Sets the service name to "ISPservice".
Sets the VPI to 30 and the VCI to 33.
Sets the WAN IP address to be dynamic.
Saves the settings.
Sets the active node profile to node 2 again.
wan node routeip <on|off> Activates or deactivates IP routing on the
previously-specified WAN node profile.
wan node save Saves configured information about the WAN node
you previously specified with the wan node index
<node#> command to the permanent memory.
Note: Changes to the configuration in the
working buffer are not saved or
used until you enter this command.
wan node scr <scr> Sets the Sustainable Cell Rate (SCR) of the
previously-specified WAN node profile.
wan node service <name> Sets the PPPoE service name of the previously-
specified WAN node profile.
wan node vci <vci> Sets the VCI (Virtual Channel Identifier) of the
previously-specified WAN node profile.
wan node vpi <vpi> Sets the VPI (Virtual Path Identifier) of the
previously-specified WAN node profile.
wan node wanip <<static>
<ip>>|<dynamic>
Sets the WAN IP address of the previously-specified
WAN node profile.
Table 66 wan node Commands (continued)
COMMAND DESCRIPTION