ZyXEL Communications n/a Modem User Manual


 
Chapter 19 System Commands
DSL & IAD CLI Reference Guide
123
sys logs mail logAddr [mail-
address]
Sets or displays the e-mail address to send logs to.
sys logs mail passwd [smtp-user-
password]
Sets the SMTP authentication password.
sys logs mail port [port] Sets the port number for sending log e-mails.
sys logs mail schedule display Displays the log email schedule, including day and time and whether
an immediate alert is required.
sys logs mail schedule hour <0-
23>
Sets the hour to send the logs.
sys logs mail schedule minute <0-
59>
Sets the minute to send the logs.
sys logs mail schedule policy
<0:full|1:hourly|2:daily|3:weekl
y|4:none>
Sets how often the ZyXEL Device sends log e-mails.
sys logs mail schedule week
<0:sun|1:mon|2:tue|3:wed|4:thu|5
:fri|6:sat>
Sets the day of the week to send the e-mail log.
sys logs mail sendmail Immediately sends a log by e-mail.
sys logs mail server <domain-
name|ip-address>
Specifies the server name or the IP address of the mail server for the
e-mail address specified as the mail sender.
sys logs mail subject <mail-
subject>
Specifies the title in the subject line of the diagnostic e-mail message
that the ZyXEL Device sends.
sys logs mail user [smtp-
username]
Specifies (or displays) the user name (up to 31 characters) for the e-
mail account the ZyXEL Device uses for e-mailing logs.
sys logs save Saves the log settings to long term memory.
sys logs syslog active
[0:no|1:yes]
Enables or disables the UNIX syslog.
sys logs syslog display Displays the syslog settings, including status, syslog IP address and
log facility.
sys logs syslog facility [local-
id]
Logs the messages to different files located on the syslog server.
local-id: The number of files available depends on the syslog
utility used. For example, the Kiwilog supports seven files.
sys logs syslog server [domain-
name|ip-address]
This sets the domain name and IP address for the syslog server to
send the logs.
sys password <new-password> Sets the system administrator password.
sys pwderrtm [minute] Sets or displays the password error blocking timeout value in
minutes. Not devices support this command.
sys qe acl add <ila> <ilp> <oga>
<ogp> <proto> <direction>
Adds an ACL rule in the QE (quick engine) ACL table.
ila: Enters the inside local address, that is the source or destination
address of packets on the LAN.
ilp: Enters the inside local port.
oga: Enters the outside global address, that is the source or
destination address of packets on the WAN.
ogp: Enters the outside global port.
proto: Specifies the protocol type. 1: TCP, 0: UDP
direction: Specifies the traveling direction of the packets. 1:
outgoing, 0: incoming
Table 44 sys Commands (continued)
COMMAND DESCRIPTION