Filter
Top Products
Chapter 21 WAN Commands
DSL & IAD CLI Reference Guide
166
wan node multicast
<none|igmpv1|igmpv2>
Sets the multicast mode of the previously-specified
WAN node profile.
wan node mux <vc|llc> Sets the multiplexing protocol used by the
previously-specified WAN node profile.
<vc>: virtual circuit-based
<llc>: logical link control-based
wan node nailedup <on|off> Activates or deactivates a nailed-up (always on)
connection for the previously-specified WAN node
profile.
wan node nat <none|sua|<full
<rule#>>
Sets the Network Address Translation (NAT)
method of the previously-specified WAN node
profile.
<off>: NAT is not active
<sua>: Use Single User Account only (if you have
just one public WAN IP address for your ZyXEL
Device).
<full> : Use full-feature NAT (if you have multiple
public WAN IP addresses for your ZyXEL Device).
<rule#> : When you choose full-feature NAT,
specify the address mapping rule to apply. Use the
ip nat addrmap rule command to configure
address mapping rules.
wan node pcr <pcr> Sets the Peak Cell Rate (PCR) of the previously-
specified WAN node profile.
wan node ppp authen <pap|chap|both> Sets the PPP authentication method for the
previously-specified WAN node profile.
wan node ppp idletime <seconds> Sets the PPP idle timeout.
wan node ppp password <password> Sets the PPP password for the previously-specified
WAN node profile
wan node ppp username <username> Sets the PPP user name for the previously-specified
WAN node profile
wan node private <yes|no> Specifies whether the previously-specified WAN
node is private or not.
This command determines whether or not the
ZyXEL Device includes the route to this remote
node in its RIP broadcasts. If you select yes, this
route is not included in RIP broadcast. If you select
no, the route to this remote node is propagated to
other hosts through RIP broadcasts.
wan node qos
<ubr|cbr|vbr_nrt|vbr_rt>
Sets the QoS (Quality of Service) type used by the
previously-specified WAN node profile.
<ubr>: Unspecified Bit Rate
<cbr>: Constant Bit Rate
<vbr_nrt>: Variable Bit Rate (Non-Real-Time)
<vbr_rt>: Variable Bit Rate (Real-Time)
wan node remoteip <ip-address>
<subnet>
Sets the remote gateway IP address of the
previously-specified WAN node profile.
wan node rip <none|in|out|both>
<rip1|rip2b|rip2m>
Sets the Routing Information Protocol (RIP) mode
and type of the previously-specified WAN node
profile.
Table 66 wan node Commands (continued)
COMMAND DESCRIPTION