Filter
Top Products
DSL & IAD CLI Reference Guide
153
CHAPTER 21
WAN Commands
Use these commands to configure the ZyXEL Device’s WAN settings.
21.1 wan adsl Commands
Use these commands to configure the ZyXEL Device’s ADSL interface settings.
21.1.1 wan adsl Examples
The following example:
• Resets the ADSL modem.
• Displays the firmware version.
Table 61 wan adsl Commands
COMMAND DESCRIPTION
wan adsl chandata Shows the ADSL channel data and line rate.
wan adsl close Closes the ADSL line.
wan adsl coinfo Displays information on the current modem status.
wan adsl fwversion Displays the current DSL firmware version.
wan adsl linedata far Shows ADSL far end noise margin and carrier load
information.
wan adsl linedata near Shows ADSL near end noise margin and carrier
load information.
wan adsl open Opens the ADSL line.
wan adsl opencmd
<adsl2|adsl2+|gdmt|multimode>
Opens the ADSL line with the specified standard.
wan adsl opmode Shows the ADSL operational mode (standard).
wan adsl perfdata Shows performance information such as the CRC,
FEC, error seconds.
wan adsl rateadap <on|off> Activates or deactivates rate adaption.
wan adsl reset Resets the ADSL modem to the saved
configuration.
wan adsl status Displays ADSL status (up, down or initializing).
wan adsl targetnoise
<target_noise_margin>
Sets the target noise margin.
target_noise_margin: -31 ~ 32.
wan adsl version Displays the ADSL firmware version.