Filter
Top Products
Panel Calibration
91
VG-Series Modero Touch Panels
Panel Calibration
Overview
This section outlines the steps for calibrating the touch panel. It is recommended that you calibrate the
panel before its initial use and after completing a firmware download.
Modero panels are factory setup with specific demo touch panel pages. The first splash screen that
appears indicates the panel is receiving power, beginning to load firmware, and preparing to display the
default touch panel pages. When the panel is ready, the AMX Splash Screen is replaced by the Initial
Panel Page (FIG. 67).
Calibrating the Modero Panel
1. Press and hold the grey Front Setup Access button (FIG. 68) for 6 seconds (passing-over the Setup
page) to access the Calibration setup page (FIG. 69). The panel should first be calibrated properly.
FIG. 67 AMX splash screen and Initial Panel Page
FIG. 68 Location of grey Front Setup Access button
AMX Splash Screen
(appears during power-up)
Initial Panel Page
(AMX Logo Page)
Front Setup
Access button (grey)
- 3 second press/hold:
Accesses the Setup page
- 6 second press/hold:
Accesses the Calibration
page
Single press puts
the panel to sleep