Filter
Top Products
Firmware Pages and Descriptions
143
VG-Series Modero Touch Panels
RGB Adjustment Page Elements (Cont.)
Settings: • The Default Settings button sets the RGB settings to their default values
(indicated in this table).
• The Undo Changes button disregards any changes made on the page since
the last settings were saved.
• The Save Settings button saves any changes made to the RGB Adjustment
page.
• The Sync on Green button sets the NXA-RGB card to search for the sync
signal on Green signal.
Version: Displays the firmware version being used by the internal NXA-RGB card.
BOB Version: Displays the firmware version of the communicating NXA-AVB/RGB Breakout
Box.
• If firmware is updated to either the panel or the breakout box, both units must
be power-cycled for the panel to detect and display the BOB firmware
version.
Status: Displays the input signal properties of the signal routed through the internal
NXA-RGB card (H-pixel x V-pixel @ Hz). An example is: 1024x768@85Hz.
Cable Variance: Allows you cycle through a choice of available cable compensation parameters
(Short, Medium, and Long).
• This field adjusts the cable compensation for any signal degradation over a
selected cable length.
• This adjustment is done by using preset calculations to take into account the
length and type of cable being used to transmit the signal.
• Toggling the field can correct some signal problems.
RGB Input Resolution: Use the UP/DN buttons to alter the input resolution of the RGB signal being
routed through the internal NXA-RGB card.
• Supported Input resolutions are:
- Auto: automatically detects the incoming signal. This is the
recommended setting and should be used as the default selection.
- 560 x 192, 560 x 384, 640 x 350, 640 x 416, 640 x 480, 720 x 532,
800 x 600, 900 x 720, 1024 x 768, 1280 x 768, 1280 x 800, 1152 x 864,
1280 x 1024, 1600 x 1200, HD 480p, HD, 720p, and HD 1080i.
• Note: These displayed resolutions correspond to the supported input
resolution of the NXA-RGB card.
• Note: When using 1024 x 768, 1280 x 768, or 1280 x 800 it is
recommended that you select those specific resolutions using the input
adjustment UP/DN buttons.
Phase: Use either the slider or the UP/DN buttons to alter the RGB tracking/signal
level.
• Range = 0 - 31, default = 0.
Geometry: Provides an on-screen RGB Geometry popup dialog that allows you to select
from several location and size adjustment settings.
• Press the Adjust button to open the RGB Geometry popup dialog.
• Use the Hide button to close the popup.
• Range = 0 - 255, default = 0.
H Position Use the UP/DN buttons to alter the horizontal position level.
• Range = 0 - 255, default = 0.
H Size Use the UP/DN buttons to alter the horizontal size level.
• Range = 0 - 255, default = 0.
V Position Use the UP/DN buttons to alter the vertical position level.
• Range = 0 - 255, default = 0.