Filter
Top Products
Touch Panel Accessories
40
VG-Series Modero Touch Panels
Step 4: Install the Compact Flash Memory Card upgrade
1.
Discharge any static electricity from your body by touching a grounded metal object and then locate
the existing Compact Flash card (factory-shipped with 128 MB) on the main board (FIG. 20 for
Table Top panels and FIG. 23 for Wall Mount panels).
2. Insert the tip of a grounded flathead screwdriver into one of the card removal grooves (located on
either side of the card), and gently pry the card out of the slot (FIG. 21). Repeat this process on the
opposite card removal groove. This alternating action causes the card to "wiggle" away from the
on-board connector pins.
3. Grip the old card by its sides and then carefully pull it out of the slot.
FIG. 19 Location of the NXA-RGB card and I/O plate
FIG. 20 Location of the Compact Flash card and I/O plate on NXT
RGB I/O
NXA-RGB card
Outer Housing
NXA-RGB card
screw locations (4)
connector plate
I/O connector
Compact Flash card
Outer Housing
plate
Eight Housing
Screws
NXA-PCI80211G
wireless card
location