Filter
Top Products
Firmware Pages and Descriptions
155
VG-Series Modero Touch Panels
Protected Setup Page Elements (Cont.)
System Recovery: Allows you to either reset the touch panel to factory default settings and/or wipe
out all existing touch panel pages:
• The Reset System Settings button allows a user to wipe out all current
configuration parameters on the touch panel (such as IP Addresses, Device
Number assignments, Passwords, and other presets).
- Pressing this button launches a Confirmation dialog (FIG. 118) which asks
you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
• The Remove User Pages button allows you remove all current TPD4 touch
panel pages currently on the panel (including the pre-installed AMX Demo
pages).
- Pressing this button launches a Confirmation dialog (FIG. 118) which asks
you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
Keyboard Layout:
(build 2.60 or higher)
Displays the listing of supported international keyboard settings. The following
list allows the end-user to specify which international keyboard is being
connected to the Modero touch panel and then which characters should be
reflected within the G4 Computer Control and TakeNote applications:
- None (default), Spanish, Italian, French, German, Swiss, UK, and US
Note: You must be using a standard 101 button keyboard to accurately
utilize this feature.
• Modero uses the open-source VNC character standards to transmit the
character information to a target device such as a PC.
• One of the issues which occurred in the past was that some 101-key foreign
keyboard character sets were being incorrectly represented via the Computer
Control and Take Note applications.
• For example: Spanish keyboards consisting of Castilian character sets such
as tilde (
é) were being miscommunicated by the VNC application to the
source computer and as a result, passwords were not properly being entered.
• The VNC - Computer Control keyboard drivers found in earlier Modero
firmware (build 57 or earlier) were using an English type/character set which
was not fully utilizing all available foreign characters.
• Several different countries have produced 101-key international keyboards,
each with their own unique set of keys occupying the keyboard. Several of
these keys are specific to the language they are used with.
FIG. 118
Protected Setup page-System Recovery confirmation dialog
You have a wait time of 5 seconds
before the YES option is enabled.