Filter
Top Products
Troubleshooting
234
VG-Series Modero Touch Panels
Troubleshooting Information (Cont.)
Symptom Solution
After downloading a panel file or
firmware to a G4 device, the panel
behaves strangely.
Symptoms include:
• Having to repeat the download.
• Inability to make further downloads to the panel. May get "directory"
errors, "graphics hierarchy" errors, etc.… indicating problems with
the Compact Flash.
• Panel will not boot, or gets stuck on "AMX" splash screen.
• Other problems also started after downloading to a new panel or a
panel with a TPD4 file that takes up a considerable amount of the
available Compact Flash.
Cause:
• If the G4 device already contains a large enough file, subsequent
downloads will take up more space than is available and could often
corrupt the Compact Flash. The demo file that typically ships with G4
panels is one such file.
Solution:
• DO NOT download TPD4 files (of large size) over the demo pages, or
any other large TPD4 file.
• First download a small blank one page file to the G4 panel using the
Normal Transfer option to send/download the page. Reboot the
device, then do your regular file or firmware download.
My NXA-BASE/B Battery Base
isn’t being recognized by the NXT
touch panel.
The battery base CAN NOT be "hot swapped". This swapping
occurs when an NXT panel is currently being powered by a PSN6.5
and then is connected to a battery base containing NXT-BP batteries.
Introducing a new power source onto an existing configuration can
damage the NXA-BASE.
Solution:
If your base is not being recognized by the touch panel but is still
providing power:
• Launch the latest NetLinx Studio.
• Refresh the particular System from within the OnLine Tree tab.
• Identify the NXT panel using the battery base.
• From the Main menu go to Tools > Firmware Transfers > Send to
NetLinx Device.
• Locate and select the 2250_XXX_v2 KIT file for the battery base.
• Enter the Device and System values, verify the method of
communication (IP recommended).
• Click Send to reload the new base KIT file onto the NXA-BASE/B.
If this above steps do not cause the base to be recognized by the NXT
touch panel on the Setup page, contact AMX Technical Support for
further assistance.
The Battery Base button doesn’t
appear on the panel’s Setup page.
• Refer to the above troubleshooting symptom.
My RGB image looks blurry. The
edges of the characters appear
shadowed and/or blurry.
• Refer to the Adjusting the Incoming Signal on the RGB Adjustment
Page section on page 145 for more detailed information on adjusting
the skew of the incoming image.