Filter
Top Products
Touch Panel Accessories
43
VG-Series Modero Touch Panels
Step 2: Install the new 802.11g mini-PCI Wireless card (NXD)
Complete the procedures outlined within Step 2: Install the 802.11g mini-PCI Wireless Card section on
page 38 and then continue with the following step.
Step 3: Install the new RGB Card Component (NXD)
1.
Discharge any static electricity from your body by touching a grounded metal object.
2. Locate the RGB card’s slot connector on the main board and align it with its counterpart on the
bottom of the NXA-RGB card.
3. Carefully, but firmly, insert the NXA-RGB card into the RGB connector slot on the main board until
both the card rests atop the four raised securing holes and the RGB RJ-45 connector is evenly
aligned with the other RJ-45 connectors on the back of the panel.
4. Use a grounded Phillips-head screwdriver to secure the four NXA-RGB pan-head securing screws
to the raised securing holes on the main board. Refer to the Step 3: Install the NXA-RGB Card
Component (NXT) section on page 39 for more information.
Step 4: Install the new Compact Flash Memory card (NXD)
1.
Complete the procedures outline within Step 4: Install the Compact Flash Memory Card
upgrade section on page 40 and then continue with the following step.
Step 5: Close and Resecure the NXD Panel Enclosure
1.
With the components securely installed, gently place the outer housing back onto the metallic panel
casing (with the connector opening on the right-side of the panel) and align the four pan-head
Housing Screw holes along the edges of the outer housing.
2. Insert and secure the four pan-head Housing Screws into the pre-drilled holes along the edges of the
NXD unit by using a grounded Phillips-head screwdriver.
FIG. 23 Location of the Compact Flash card and I/O plate on NXD
Outer Housing
Compact Flash card
I/O connector
plate
NXA-PCI80211G
wireless card
location
Four Pan-head
Housing
Screws
Use care not to bend or damage any antenna connections while replacing the outer
housing.