Filter
Top Products
Programming
225
VG-Series Modero Touch Panels
Input Commands
These Send Commands are case insensitive.
Input Commands
^CAL
Put panel in
calibration mode.
Syntax:
"'^CAL'"
Example:
SEND COMMAND Panel,"'^CAL'"
Puts the panel in calibration mode.
^KPS
Set keyboard
pass-thru via the
RGB card.
Syntax:
"'^KPS-<passs data>'"
Variables:
pass data:
<blank/empty> = Disables the keyboard.
0 = Pass-thru disabled.
1 = Not used.
2 = Pass-thru enabled.
3 & 4 = Not used.
5 = Sends out data to the Master.
Example:
SEND COMMAND Panel,"'^KPS-5'"
Sets the keyboard pass-thru to the Master. Option 5 sends keystrokes directly to the
Master via the Send Output String mechanism. This process sends a virtual keystroke
command (^VKS) to the Master.
Example 2:
SEND COMMAND Panel,"'^KPS-0'"
Disables the keyboard pass-thru to the Master.
The following point defines how the parameters within this command work:
• Accepts keystrokes from any of these sources: attached USB keyboard or Virtual
keyboard.
^MPS
Set the mouse
pass-thru.
Syntax:
"'^MPS-<pass data>'"
Variables:
pass data:
<blank/empty> = Disables the mouse.
0 = Pass-thru disable.
1 = Not used.
2 = pass-thru enable.
3 - 5 = Not used.
Example:
SEND COMMAND Panel,"'^MPS-2'"
Sets the mouse pass-thru via the NXA-RGB card.
Note: When this command is given, it causes all mice connected to the G4 product and
any mice on a computer connected via a card with USB output to reset to position 0,0.