Filter
Top Products
Installation Procedures: 17" Panels
86
VG-Series Modero Touch Panels
18. Reconnect the terminal RJ-45, Ethernet, and any optional audio/video wiring to their respective
terminal locations on either the NXA-AVB/RGB Breakout Box, Ethernet port, or NetLinx Master.
19. Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.
Installing an NXD into an (optional) Rack Mount Kit (NXA-RK17)
1.
Remove the magnetic faceplate/bezel from the main NXD unit by gripping the faceplate and pulling
with gentle outward force.
2. Thread the incoming RJ-45, Ethernet, and any optional audio/video wiring (from their terminal
locations) through the opening in the equipment rack. Refer to the Wiring Guidelines for the
1700VG Panels section on page 87 for pinout descriptions. Leave enough slack to accommodate
any re-positioning of the panel.
3. Connect all data and power wiring connectors to their corresponding locations along the side of the
(un-powered) NXD touch panel.
Verify the terminal end of the power cable is not connected to a power supply before plugging
in the 2-pin power connector.
4. Test the incoming wiring by connecting the panel connections to their terminal locations and
applying power. Verify the panel is receiving power and functioning properly to prevent repetition
of the installation.
5. Disconnect the terminal end of the power cable from the connected power supply.
6. Insert the main 17-inch Modero unit into the NXA-RK17 (FIG. 63).
7. Secure the panel to the NXA-RK17 mount frame by first inserting and then tightening the four
#4-40 screws.
8. Insert the NXA-RK17 (with connected NXD unit) into the equipment rack, making sure to align the
screw holes along the sides of the NXA-RK17 with the holes in the equipment rack.
Don’t disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the equipment rack.
FIG. 63 NXD-1700VG Wall Mount panel installed into an NXA-RK17 Rack Mount Kit
15.72
399.29
3.31
84.03
19.00
482.60
Faceplate