Filter
Top Products
To specify the
communication speed and the duplex settings of Ethernet. The change becomes
effective after
the multifunction printer is turned off and then on again.
Values:
TCP/IP
Purpose:
To specify the TCP/IP settings for the wired network. The change becomes effective after the multifunction
printer is turned off and then on again.
Values:
Auto*
Detects the Ethernet settings automatically.
10 Base Half
Uses 10base-T half-duplex.
10 Base Full
Uses 10base-T full-duplex.
100 Base Half
Uses 100base-TX half-duplex.
100 Base Full
Uses 100base-TX full-duplex.
IP Mode*
1
Dual Stack
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode*
3
Uses IPv6 to set the IP address.
IPv4 Get IP Address AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the
keys on the operator panel.
Subnet Mask
Sets the subnet mask.
Gateway Address
Sets the gateway address.
Page
28
of
61
Understanding Menus
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...