Filter
Top Products
Printing a Network Configuration Page
The Network Configuration page shows how the network interface card on your multifunction printer is
configured. The default settings are suitable for most applications.
1. Press until >SETUP appears, and then press .
2. Press until >Admin Menu appears, and then press .
3. Press until >Admin Reports appears, and then press
4. Press until >Server Address appears, and then press .
The Network Configuration page prints out.
Setting Network Protocols
When you first install the multifunction printer, all supported network protocols are enabled when you power
the multifunction printer on. If a network protocol is enabled, the multifunction printer may actively transmit
on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate
unnecessary traffic, you can disable unused protocols.
1. Press until >SETUP appears, and then press .
2. Press until >Admin Menu appears, and then press .
3. Press until >Wired Net or >Wireless Net appears, and then press
4. Press until >Protocol appears, and then press
5. Press to select the desired settings, and then press
z Port9100
z FTP
z SNMP UDP
z E-Mail Alert
z EWS
Configuring TCP/IP
Dynamic Addressing Server
· DHCP
· BOOTP
Page
6
of
8
Networking
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...