Filter
Top Products
IP Filter (IPv4)
Purpose:
To specify that data received from certain IP addresses through the wired network is blocked. You can set up
to five IP addresses. The change becomes effective after the printer is turned off and then on again.
Values:
Initialize NVM
Purpose:
To initialize wired network data stored in NVM. After executing this function and rebooting the printer, all
wired network settings are reset to their default values.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol settings
for the wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Ethernet II
Ethernet 802.3
Uses the IEEE802.3 frame type.
Ethernet 802.2
Uses the IEEE802.2 frame type.
Ethernet SNAP
Use the SNAP frame type.
NOTE: The IPX/SPX menu is only displayed when an optional multi-protocol card is installed on the
printer and the optional wireless printer adapter is not installed on the card.
Filter*
1
No. n/Address (n is 1-5.)
Sets the IP address for Filter n.
No. n/Mask (n is 1-5.)
Sets the mask for Filter n.
No. n/Mode (n is 1-5.) Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
*
1
This item is only available for LPD or Port9100.
Page
31
of
61
Understanding Menus
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...