Filter
Top Products
5. Press until the desired tone appears, and then press .
6. Press until the desired volume appears, and then press .
The multifunction printer works normally even if the ringer is turned off.
7. Press Cancel to return to the standby mode.
Speaker Volume
1. Press until >FAX appears, and then press .
2. Press until >OnHook appears.
3. Press to select On, and then press .
4. Press Cancel to return to the standby mode.
Sending a Delayed Fax
The Delayed Start mode can be used to save scanned documents for transmission at a specified time in order to take advantage of lower long distance
rates.
1. Load the document(s) face up with top edge in first into the ADF.
OR
Place a single document face down on the document feeder glass.
For details about loading a document, see "Loading an Original Document".
2. Press until >FAX appears, and then press .
3. Adjust the document resolution to suit your fax needs (see "Adjusting the Document Resolution").
If you need to change the contrast, see "Lighter/Darker".
4. Press until >Delayed Start appears.
5. Press to select On, and then press .
6. Enter the start time using the number keypad.
7. Enter the number of the remote machine using the number keypad, and then press .
To enter the number, you can use speed dial or group dial numbers. For details, see "Automatic Dialing".
Press Start to scan data.
Once Delayed Start mode is activated, your multifunction printer stores all of the documents to be faxed into its memory and sends them at the
programmed time. After faxing in the Delayed Start mode is complete, the data in the memory is cleared.
Specifying the Fax Settings
Changing the Fax Settings Options
1. Press until >SETUP appears, and then press .
2. Press until >Admin Menu appears, and then press .
3. Press until >Fax Settings appears, and then press .
4. Press until the desired menu item appears, and then press .
5. Use to find the status or use the number keypad to enter the value for the option you have selected.
6. Press to save the selection.
7. Press Back to return to the previous screen.
8. If necessary, repeat steps 4 through 7.
9. To return to the standby mode, press Cancel.
NOTE: You can turn on/off the speaker only when the telephone line is connected.
Page
4
of
20
Faxing
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...