Filter
Top Products
Initialize NVM
Purpose:
To initialize wireless network data stored in NVRAM.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings for
the wireless network. The change becomes effective after the multifunction printer is turned off and then on
again.
Values:
Parallel Settings
The Parallel Settings menu can be adjusted to configure the parallel interface.
ECP
IP Filter*
1
No. n/Address (n is 1-5.)
Sets the IP address for Filter n.
No. n/Mask (n is 1-5.)
Sets the mask for Filter n.
No. n/Mode (n is 1-5.) Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
*
1
This item is only available for LPD or Port9100.
Auto
Used when auto-detecting the PostScript communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between
them according to the specified control code.
Binary
Used when no special processing is required.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Page
36
of
61
Understanding Menus
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...