Filter
Top Products
Purpose:
To specify the TCP/IP settings for the wireless network. The change becomes effective after the printer is
turned off and then on again.
Values:
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the multifunction printer is turned off and
then on again.
Values:
IP Mode*
1
Dual Stack
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode*
3
Uses IPv6 to set the IP address.
IPv4 Get IP Address AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the
keys on the operator panel.
Subnet Mask
Sets the subnet mask.
Gateway Address
Sets the gateway address.
Reset IPsec*
2
Disables IPsec.
*
1
Only displayed when an optional multi-protocol card is installed on the printer.
*
2
Only displayed when IPsec is enabled.
*
3
This mode is available only when firmware version 200706291103 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the
printer driver is not available when using this mode.
Page
33
of
61
Understanding Menus
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch
...