Filter
Top Products
MMB CLI (Command Line Interface) Operations
2.2.14 set partition dynamic_partitioning
Sets the enable/disable of Dynamic Reconfiguration of the specified partition.
When executing the settings by this command for the partition whose power is already on, message shown
below is displayed, and settings cannot be done.
“Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown.”
When settings of the partition for which power supply is already switched off are to be changed, it is not
necessary to turn On / Off the power supply. The value set at that instant is reflected without displaying the
above-mentioned message.
Moreover, when existing value and set value are same, it is not necessary to turn On / Off the power supply,
and above mentioned message is not displayed.
Privilege: Administrator, Operator, Partition Operator (Only the Partition to be
managed)
(1) Input format
set partition dynamic_partitioning<partition#>[disable|enable]{quiet}
(2) Option
quiet: Does not display message.
(3) Usage example
Example : When Dynamic Reconfiguration of partition #3 is enabled
# set partition dynamic_partitioning 3 enable
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
The specified partition number is invalid.
The specified parameter is invalid.
Unable to execute this command on a standby MMB
Failed to execute set partition dynamic_partitioning command.
Unable to change the mode while the partition is running.
Please try to change the mode after the partition is shutdown.
DP can't be enabled, because of no DP license.
2.2.15 set gateway
Default gateway is set
Set value is 0.0.0.0 by default.
Privilege: Administrator
(1) Input format
set gateway<ip address>