Fujitsu C122-E177-01EN Computer Hardware User Manual


 
MMB CLI (Command Line Interface) Operations
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
Failed to get login information.
2.3.31 help
Displays the help of enabled command.
Privilege: A
ll
(1) Input format
help
(2) Option
None
(3) Usage example
[When the PRIMEQUEST 2800B model]
Example 1: For the Administrator privilege
#help
factory_default {-f}
add partition <partition#> [ SB <SB#> | IOU <IOU#> ] {quiet}
clear access_control
power off {partition} [ all | <partition#>[,| -]<partition#>] {force}
power on {partition} [ all | <partition#>[,|-]<partition#>]
remove partition <partition#> [ SB <SB#> | IOU <IOU#> ] {quiet}
set active_mmb {0 | 1} {quiet}
set date MMDDhhmm{{CC}YY}{,ss}
set timezone <timezone>
set gateway <ip address>
set gateway_ipv6 [auto | <ip address>]
set [ http | https | ssh | telnet ] [ enable | disable ]
set [ http_port | https_port | ssh_port | telnet_port ] <port>
set partition home <partition#> SB <SB#>
set partition name <partition#> <partition name>
set partition dynamic_partitioning <partition#> [disable | enable] {quiet}
set partition memory_operation_mode <partition#> [performance | normal | partial_mirror | spare]
{quiet}
set partition memory_mirror_ras_mode <partition#> [mirror_keep | capacity_keep] {quiet}
set partition pci_address_mode <partition#> [bus | segment] {quiet}
set partition pci_express_mode <partition#> [ flexible | fixed ]
set partition lan_device_mode <partition#> <IOU#> [wol_enable | wol_disable | device_disable] {quiet}
set ip <ip address> <netmask>
set ipv6 [auto | <ip address>/<prefix>]
set hostname <hostname>.<domain name>
set maintenance_ip <ip address> <netmask> <gateway address> <smtp address>
set sysconf power_feed_mode [single | dual] {quiet}
set sysconf power_restoration_policy [on | off | restore | sync] {quiet}
set sysconf power_on_delay <time> {quiet}
set sysconf altitude <altitude>
set sysconf psu_redundant_mode [redundant | non_redundant] {quiet}
set mmbcontrol reset [0 | 1] {quiet}
set mmbcontrol switch_over {quiet}
set reserved_sb <SB#> <partition#> {quiet}