Filter
Top Products
190 21555 Non-Transparent PCI-to-PCI Bridge User Manual
List of Registers
16.14 JTAG Registers
This chapter presents the theory of operation information about the 21555 JTAG registers. See Chapter 13 for
theory of operation information.
5:4 Reserved R Returns 0 when read.
6REM STAT
R/
W1TC
Signal p_enum_l Removal Status. The 21555 sets this bit to a 1 when
l_stat is sampled high and p_rst_l is deasserted, signaling an
impending removal. This bit is cleared when software writes a 1.
Clearing this bit causes the 21555 to tristate l_stat. Writing a 0 has no
effect.
• When 1, the 21555 is asserting p_enum_l to indicate that the card
is about to be removed.
• Reset value is 0
7INS STAT
R/
W1TC
Signal p_enum_l Insertion Status. The 21555 sets this bit to a 1 when
l_stat is sampled low (ejector handle is closed), the serial preload is
complete and the Primary Lockout Reset Value bit is cleared, indicating
that the card is ready for host initialization. This bit is cleared when
software writes a 1. Writing a 0 has no effect.
• When 1, the 21555 is asserting p_enum_l to indicate that the card
has just been inserted.
• Reset value is 0
Table 126. JTAG Instruction Register Options (Sheet 1 of 2)
The 4-bit instruction register selects the test mode and features. The instruction codes are shown
in
Table 126. These instructions select and control the operation of the boundary-scan and bypass
registers. The instruction register is loaded through the tdi pin. The instruction register has a
serial shift-in stage from which the instruction is then loaded in parallel.
Instruction Register
Contents
Instruction
Name
Test Register
Selected
Operation
0000 EXTEST Boundary
-scan
External test (drives pins from
boundary
-scan register).
0001 SAMPLE Boundary
-scan Samples inputs.
0010 HIGHZ Bypass
Tristates all output and I/O pins except
the tdo pin.
† Manufacturer’s identification number: 0000 0001 0011
Design part number: 1001 0010 0110 0010
Version: 0000
Table 125. CompactPCI Hot-Swap Control Register (Sheet 2 of 2)
• Primary byte offset: EF:EEh
• Secondary byte offset: EF:EEh
Bit Name R/W Description