Filter
Top Products
5-16
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Chapter 5 Installing the IPS 4270-20
Accessories
Accessories
The IPS 4270-20 accessories kit contains the following:
•
DB-9 connector
•
DB-9/RJ-45 console cable
•
Two Ethernet RJ-45 cables
•
Regulatory Compliance and Safety Information for the Cisco Intrusion Detection and Prevention
System 4200 Series Appliance Sensor
•
Documentation Roadmap for Cisco Intrusion Prevention System
Installing the Rail System Kit
You can install the IPS 4270-20 in a 4-post rack. This section describes how to install the IPS 4270-20
in a rack, and contains the following sections:
•
Understanding the Rail System Kit, page 5-16
•
Rail System Kit Contents, page 5-17
•
Space and Airflow Requirements, page 5-17
•
Installing the IPS 4270-20 in the Rack, page 5-18
•
Extending the IPS 4270-20 from the Rack, page 5-26
•
Installing the Cable Management Arm, page 5-28
•
Converting the Cable Management Arm, page 5-32
Understanding the Rail System Kit
This rail system supports a variety of products that can be installed in round-, square, or threaded-hole
racks. The following illustration shows the three rack hole-types. Use Figure 5-11 to identify your rack
type and then follow the installation steps accordingly.
Figure 5-11 Round-, Square-, and Threaded-Hole Racks
250205
Round-hole racks Square-hole racks Threaded-hole racks
No tools required No tools required Tools required:
standard screwdriver,
Phillips screwdriver,
or T-25 Torx driver