Filter
Top Products
E-38
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.1
OL-24002-01
Appendix E Troubleshooting
Troubleshooting the Appliance
Sensor up-time is 13 days.
Using 4395M out of 5839M bytes of available memory (75% usage)
system is using 26.2M out of 160.0M bytes of available disk space (16% usage)
application-data is using 69.7M out of 171.6M bytes of available disk space (43%
usage)
boot is using 57.3M out of 70.5M bytes of available disk space (86% usage)
application-log is using 494.0M out of 513.0M bytes of available disk space (96%
usage)
MainApp S-2011_NOV_16_00_20_7_1_3_46 (Release) 2011-11-16T00:23:0
6-0600 Running
AnalysisEngine S-2011_NOV_16_00_20_7_1_3_46 (Release) 2011-11-16T00:23:0
6-0600 Running
CollaborationApp S-2011_NOV_16_00_20_7_1_3_46 (Release) 2011-11-16T00:23:0
6-0600 Running
CLI S-2011_NOV_16_00_20_7_1_3_46 (Release) 2011-11-16T00:23:0
6-0600
Upgrade History:
IPS-K9-7.1-3-E4 00:30:07 UTC Wed Nov 16 2011
Recovery Partition Version 1.1 - 7.1(3)E4
Host Certificate Valid from: 16-Nov-2011 to 16-Nov-2013
sensor#
Note
If you do not have the latest software updates, download them from Cisco.com. Read the
Readme that accompanies the software upgrade for any known DDTS for the ARC.
Step 5
Make sure the configuration settings for each device are correct (the username, password, and IP
address).
Step 6
Make sure the interface and directions for each network device are correct.
Step 7
If the network device is using SSH-3DES, make sure that you have enabled SSH connections to the
device.
Step 8
Verify that each interface and direction on each controlled device is correct.
For More Information
•
For the procedure for obtaining the latest Cisco IPS software, see Obtaining Cisco IPS Software,
page C-1.
•
For more information about configuring devices, see Device Access Issues, page E-39.
•
For the procedure for verifying the interfaces and directions for each network device, see Verifying
the Interfaces and Directions on the Network Device, page E-40.
•
For the procedure for enabling SSH, see Enabling SSH Connections to the Network Device,
page E-41.